How to fit a door handle the kit you ll need.
How to fit a door handle step by step.
Be careful to fit the latch into the chiselled area and screw into the pilot holes that were made earlier.
Create a mortise for the plate around the latch on your door using the technique described above.
Then use a drill to make the necessary holes for installation of your doorknob door handle and lock.
If you re fitting your handle with the door already hung it s crucial that it doesn t move while you re drilling.
Before starting this next step read the instructions in the door handle kit every kit may be slightly different.
Mark your brand new door with the location of your handle.
Use this to make all of the pilot holes on the front back and side of the door larger.
Holding exterior handle in the proper horizontal position insert the handle with shaft attached through the backplate and door gear handle hole until handle is firmly seated against the nylon bushing.
After drilling the pilot holes insert a larger drill bit in the cordless drill.
A step by step guide to how to fit door handles.
Check out more of our diy and decorating ideas.
Create a mortise and holes for your lock and door handle.
How to fit a door handle.
Marking the door handle positions.
Drill latch and spindle.
Luckily replacing a handle or knob is a quick and easy diy project just follow our step by step instructions on how to fit a door handle.
Using the screws that came with your door handle kit attach the faceplate to the door.
Drill the screws carefully being sure to keep your drill level with the floor.
Before you can fit a door handle to a new door you will first need to mark regions to be drilled and cut.
You should use a high quality wedge or doorstop to hold the door still.
Insert the new latch.
This process will vary somewhat based on the doorknob you are installing.
Ensure the flat side of the bolt faces into the room so that you are able to lock the door from the inside.
Here s a simple step by step guide for how to put a door handle on once you ve removed the old one.
While holding exterior handle in place slide interior handle onto shaft and press both handles together until secure and tight to backplates.