How To Fix A Cupboard Door Hinge

If the barrel screws are covered start by removing the cover to reveal the screws that will adjust the door horizontally and in and out.

How to fix a cupboard door hinge.

Some depth screws move the door as you turn them. Then bore out the stripped holes with a 3 8 inch diameter bit. Pick a bit slightly smaller than the insert width for a tight fit. Once the door hinge is out of the way carefully drill out the hole where the screw used to be.

Fold a matchbook cover or piece cardboard of similar thickness four times. If you ve got a door hinge that squeals every time you open the door we ve got the fix for you. Open up the cupboard doors and locate the locking screws. Open the door and insert the matchbook cover between the door and.

This is a very common problem when cupboard. Remove the screws that hold the loose hinge leaf to the door jamb. Keep the door closed and work on only one hinge at a time. If the door isn t flush with the doors next to it adjust the depth screw.

To make sure it stays centered start with 1 8 inch and work your way up. Compare the drill bit width to the size of the insert to find which bit size to stop at. Choose the hinge on the end of the door that is closed. Locate and loosen the locking screws with a screwdriver.

Loosen each hinge pin by tapping an 8d nail up from underneath. This screw moves the door in or out. This is a video to show you all how to adjust the hinges on any cabinet or in this case a pantry cupboard door. Use a screwdriver to loosen them so that you can adjust the cabinet doors.

Once the pin is loose pull it out lift up on the door handle to relieve pressure if the pin binds. Which are the horizontal screws on the part of the hinges closest to the back of the cupboard. The screws on the door do nothing but connect the hinge to the door so all of the adjustments will be made on the part of the hinge attached to the cabinet. For self closing cabinet hinges adjusting the door until both the top and bottom are the same distance from the cabinet face should be done first.

The front adjustment screw controls the distance between the hinge and the side of the cabinet.