First check the alignment of your closet doors.
How to fix sliding folding closet doors.
Close the wood with a c clamp and leave the clamp on for 3 to 4 hours.
Once the door is approximately under the hole in the track release the pivot.
Lubricate the rollers but not the track because lubricant will act as a magnet for dust.
Tighten the set screw.
Tap the pin back in the hole with a hammer and mount the door in its brackets.
Then retighten the screw close the doors and check the fit.
If you see an uneven gap it will require you to raise or lower one of the sides.
Remove a door by lifting and tilting the bottom out.
Watch to the end if you want to see the fun part.
If you have a sliding closet door that glides on a bottom track clean the track with a damp cloth to ensure smooth gliding.
If a roller is stuck unscrew and remove it.
Loosen the set screw on the top bracket and slide the bracket slightly along the track to adjust the space between the top of the doors.
Then the door either sags or falls out of the track.
Hold the brace along the door edge with the triangular area on the back of the door.
Every home repair must end in fun.
Repairing bifold doors begin by inserting the bottom pivot into the bracket which can be screwed to the floor to the door jamb or both.
Bi fold closet doors are some of the most used doors in your house.
Spread the crack slightly with the screwdriver and spread carpenter s glue with a toothpick.
There should be an even and uniform separation all the way along the top and bottom.
Close the door and again.
Stand back five feet or so and examine the gaps on the top and bottom.
If the rollers are damaged install replacement rollers available at home centers.
Loosen the set screw of the top pivot bracket then move the top of the door toward or away from the door jamb as necessary to make the gap even.
Then hold the spring loaded top pivot down while you swing the top of the door toward the frame and under the door track.
Take down the door and pry the pivot out of the door edge with a flat head screwdriver or pliers.
Then mark the anchor pivot pin hole centerlines.
Slam a bifold door too many times and you can split the wood where the top and bottom anchor and pivot pins sit.