How To Hang A Wreath On A Leaded Glass Door

Use a clear hook.

How to hang a wreath on a leaded glass door.

Clean that portion of the glass with rubbing alcohol. The grid on our window made it easy to center left to right. Measure your ribbon from this point to the spot on the front of the door where you d like your wreath to hang. Then loop the tied end of your ribbon under your upside down hook.

Over the years i ve tried several different ways of hanging my wreaths and after a lot of trial and error i finally stumbled upon the best way to hang a wreath without damaging the door or weatherstripping. Use a tape measure to find the center of the door widthwise and the desired height for your hanger or just hold the wreath up until it looks just right. Mark your hanging spot but on the inside of the door s glass. Hold the nail at a sight angle so that you are hammering the nail down into the door.

If the center of the wreath hits at about eye level you re good. The only problem with this is finding a good way to hang the wreath that won t damage the door or weatherstripping. Fasten this loop around the upside down hook on your door and pull the string up and over the door onto the exterior side. How to hang a wreath on a glass door.

They are made to rest on top of the door and then have a sloped piece in the front to rest the wreath on in. Once you have checked the placement hammer the nail into the door. Attach the two parts of the wreath holder on either side of the glass in the spot where you want the wreath. If you don t want any hanging accessory on the exterior of your door place a hook upside down on the interior of your door.

Measure where you want your wreath to hang. Stand with the glass door open so you can reach the outside and inside at the same time. Drop the wreath over the top of the door so that it hangs down in front. Strike the end of the nail with the hammer until the nail is able to stand itself and continue striking until the nail is firmly in the door then hang the wreath.

Otherwise use a tape measure if you re nervous to just eyeball it. Stick a piece of tape on the inside of the glass right where you want to place the suction cup on the outside of the glass.