How To Install Metal Roofing On A Steep Roof

Cut the shingles to fit around the flange s dome.

How to install metal roofing on a steep roof.

It isn t hard as long as you are careful take your time do it right and be safe. The edging or eave flashing consists of metal strips that are used to cover the perimeter of the roof. Add the metal panels. Install the roofing screws vertically along each rib in the panel.

Adhere the joint where the cut edges of the shingles meet the dome with roofing tar. Adhere the shingles adjacent to the flange with roofing tar. Try to space the screws about 12 inches apart down the entire piece of metal. Be sure the larger edge is laid so that the small edge of the next panel will overlap it.

Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line. A careful inspection will identify potential hazards and will give. And for any exposed fasteners try to avoid over tightening them. Moreover try to ensure that the screws are all aligned evenly.

If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof. A roofing harness provides the extra security you need when working on such a roof. Always begin working at the point with the longest peak to eave distance. Some roofs are so high and so steep that even working from scaffolding can be dangerous.

Preparing for a safe job on a steep metal roof requires an assessment of the roof before the job begins. Use your 1 1 4.