Install Flashing Awning

Install the flashing place the flashing between the joint of the house and the roof.

Install flashing awning.

Flashing is generally installed at any joints or edges in the roof where water could otherwise work its way in. Install waterproof flashing onto the bottom of the timber awning window frame staple a strip of waterproof flashing onto the rear of the window frame so it can fold underneath and cover the base. The video features union s advantage lok ii standing seam roofing panel which is. Step 6 make a 10 degree bend on the shingle edge of the flashing approximately 1 2 inch from the edge.

4 inches should go up the house wall and 4 inches should go on top of the porch roof shingles. Install a reverse peak flashing for the other side of the roof so the two wall edges overlap in an x nail step flashing at a peak so the roof side extends over peak flashing on the roof. Use the metal break tool to bend the flashing lengthwise in the middle according to the angle of the roof joint. However the principles are the s.

Be sure to leave yourself plenty of overhang on either side. Typically flashing is installed using roofing nails and roofing cement. The flashing on the wall should be flush against it and the porch roof portion should be on top of the shingles. Most flashing is 8 inches wide.

This video shows how to install endwall flashing with standing seam panels.