Verify that substrate dry and free of foreign material that will damage the fanfold underlayment.
Installing fanfold insulation on roof.
My house currently has cedar shake which i m removing because it is in poor condition.
12 15 moisture content or less before installing cavity insulation.
Beginning of installation means installer accepts the existing conditions.
Foam board insulation is easy to use and is a great diy way to add some insulation.
Some types of thicker foam board insulation are available but they may need to be special ordered.
You can easily go through several sheets of insulation and know that they are secure.
R tech ff is ideal in recover applications and is well suited for single ply roof applications that employ mechanically fastened or ballasted tpo pvc epdm and cspe membranes.
Consult local building codes and membrane manufacturers for system requirements.
Putting an insulation layer could help you to stay away from this issue.
Overlap seams by about 3 inches.
It comes in standard size 4 8 sheets and smaller sizes in many different thicknesses from 1 4 inch to 2 inches.
It is not the normal insulation type that can be rolled up.
Benchmark foam s tapered expanded polystyrene eps roofing system provides effective drainage for flat roofs.
If installing closed cell spray foam or other low permeance insulation to the interior it is very important to verify that the roof sheathing and framing are dry e g.
To install foil insulation roll it out parallel to the ridge and cut it with a utility knife starting at the drip edge and working your way up.
It can be touted that foam batting material is the best one to pair with metal roof insulation.
I plan on putting vinyl siding.
Another benefit of using staples is that they do not make a large hole when penetrating into the sheathing.
There are several ways you can do to insulate the metal roof.
My question is do i install fanfold foam insulation over the substrate and then put housewrap over the fanfold or do i put the housewrap on and then fanfold over that and then vinyl siding any help with this would be greatly appreciated.
R tech rigid foam fanfold insulation.
If the existing siding is damaged remove it and install tri built fanfold underlayment directly to the substrate.
Eps insulation is easy.
