Here are the steps to installing a pop up gutter drain system.
Installing gutter pops.
Locate the endpoints and hold a nail over each.
Cut a triangular section from.
How to install a pop up gutter drain.
Wrap the aluminum strip tight around the underside of the gutter.
Begin by installing a slip joint splice on each end of an inside corner fitting.
Firmly hit the top of the nails with a hammer to drive them into each point.
Use a square and pencil to mark the gutter length and cut to the line.
Secure it with eight pop rivets or sheet metal screws.
Form strip miter joint at corner cover the joint between two lengths of gutter at each corner with a strip miter a 3 inch wide strip of aluminum.
Dig a hole underneath your gutter downspout and place a catch basin in the hole.
It s much easier to join sections on the ground than to work from the top of a ladder.
We provide a fully licensed plumber to do all your gutter.
Then trim the first section of the gutter to length with tin snips.
Project step by step 20 cutting the gutter.
Hook one side of the chalk line to the nail at the start of the gutter run.
Cut a two inch long notch in the front lip of the gutter with tin snips to join a rain gutter section.
Snap the sections together.